Probe sets HOMMEL-ETAMIC T1000

The TKU probe sets are very versatile because they can replace up to three standard probes and therefore offer a low-cost alternative. The probe sets can be extended with additional probe arms.

The probe sets contain

• basic probe
• probe arm TS1 for bores
• probe arm TS1T for grooves
• probe arm TS1D for measurements on collars and directly on end faces
• probe arm protection

Probe set TKU 100, measuring range ±100 μm
With 5 μm stylus tips Art. 256 500
With 2 μm stylus tips Art. 256 658
Basic probe TKU 100
without probe arms Art. 256 502

Probe set TKU 300, measuring range ±300 μm
With 5 μm stylus tips Art. 258 551
With 2 μm stylus tips Art. 1000 3624
Basic probe TKU 300
without probe arms Art. 233 381


The basic probe of the TKU 100/300 probe set is delivered with the following probe arms.
The probe arms can also be ordered singly.


Probe arm TS1
For bores from 4 mm, max. horizontal scanning depth 33 mm.
With 5 μm/90° stylus tip Art. 230 475
With 2 μm/90° stylus tip Art. 240 805

Probe arm TS1T
For grooves with max. vertical/horizontal scanning
depth 10/33 mm.
With 5 μm/90° stylus tip Art. 231 289
With 2 μm/90° stylus tip Art. 256 624

Probe arm TS1D
For collars, directly on end faces and bores from
5 mm, distance end face – scanning point 0.2 mm,
max. horizontal scanning depth 33 mm.
With 5 μm/60° stylus tip Art. 231 291
With 2 μm/60° stylus tip Art. 240 160

The TKU 100/300 probe sets can be extended with special probe arms.
Here an excerpt from our wide range:


Probe arm TS1 SC5/60D
For small shafts and blades,
max. horizontal scanning depth 33 mm.
With 5 μm/60° stylus tip Art. 231 444

Probe arm TS1K
For bores from 0.8 mm,
max. horizontal scanning depth 12 mm.
With 5 μm/90° stylus tip Art. 233 320
With 2 μm/60° stylus tip Art. 233 336

Probe arm TS1P
With carbide tip for contour measurement up to
±300 μm profile height,
max. horizontal scanning depth 33 mm.
Art. 232 691